Low Intensity Magnetic Drum Separators are primarily designed and manufactured as low field intensity separators. They have an open magnetic system with the magnetic poles located in one plain. (Low Intensity Magnetic Drum Separators)low field intensity separators are employed for separating iron particles from bulk material whenever foreign iron disturbs the subsequent process sequences. It is also used for removing or enriching strongly magnetic content of dry minerals.
Working Of Low Intensity Magnetic Drum Separators : After the ore slurry tank into the tank after the water pipe water to the mine under the influence of mineral particles into the tank was loose state of a mine. The role of the magnetic field, magnetic mineral particles to the magnetic pole movement magnetic agglomeration occurs, and be attracted to the cylinder. (Low Intensity Magnetic Drum Separators) the polarity of the magnetic poles along the alternating direction of cylinder rotation, and at work be fixed, due to alternating magnetic pole magnetic stirring produced the phenomenon of non-magnetic minerals in the turning off, and eventually the suction surface of the cylinder is a concentrate. (Low Intensity Magnetic Drum Separators) concentrate along the edge of magnetic cylinder to the weakest at the magnetic system, mineral water spray in the unloading effect of flushing water was discharged into the concentrate tank, if it is full magnetic magnetic roller, brush roll unloading ore is carried out with . Non-magnetic or weakly magnetic minerals are left with the pulp slurry in the discharge groove, that is tailings.
Low Intensity Magnetic Drum Separators Structure: Low Intensity Magnetic Drum Separators, permanent magnetic separators, Wet Drum Magnetic Separators, magnetic separator, low-intensity magnetic separator, Magnetic Sorting Separator, Magnetic Separation Equipment, High Gradient Magnetic Separators mainly by the cylinder, roller, brush roller, magnetic system, tank, transmission parts 6 parts. (Low Intensity Magnetic Drum Separators) cylinder by a 2-3mm stainless steel plate welded into the tube, end caps for the aluminum casting or workpiece, connected with stainless steel screws and barrel. Motor or directly through the reducer promise speed motor, drive cylinder, magnetic roller and the brush roll for rotational movement. Magnetic system is an open magnetic system, mounted on the cylinder and exposed full magnetic. (Low Intensity Magnetic Drum Separators) magnets with stainless steel bolts installed in the magnetic yoke of the floor, out of cylinder yoke shaft, the shaft has shui arm fixed. Pulled the magnetic system can be adjusted shui arm angle adjustment lever can be fixed after appropriate. Tank work area with stainless steel plate, frame and other parts of the tank with ordinary steel welding.
Yes! I am Interested
Looking for Low Intensity Magnetic Drum Separators ?